- Speedo adjustment for Tremec 3650
- 1/2" or bigger fuel rails for a 2001 4V
- hesitation
- need a hand with a prob!
- 01 Cobra problems
- 4.56's in 99 Cobra?
- Cobra R intake
- Front coil-over spring rate for '01 'vert???
- Twin Turbo 2001 Cobra... Lamotta Style! (long post)
- Bolt-ons to tweak the n/a Cobra
- Turbocharge my 01 Cobra ?
- Need rings and gaskets
- ****attention Every Svt Owner******
- Pulling Valve covers on 01 Cobra???
- Kenne Bell '99-'01 Cobra SC info......
- WMS Velocity System
- 99+ Blacked Out Cobra Fog Lights
- Post in terminator forum for irs cobras.
- Porting and Polishing 4v
- ? on backspacing
- Is the axles in a 2001 and 2003 irs the same?
- Is this True (NO MORE 4V)
- what do you guys think?
- How many 99 axles have been broken, How long will they last?
- 8 Rib pulley conversion for paxton???
- 03 T-56 any good?
- 99/01 owners, I need your paint codes.
- 99 Cobra JLT RAI/CAI dyno results! It works!
- Done porting and polishing my intake
- 2001 Cobra 8 Rib setup?
- need some info guys
- 04 heads on an 01
- Kenne Bell '99 & '01 SC Kit Install Q&A Thread
- IRS Cobras - need half shaft advice
- which cold air kit for my 2001 Cobra?
- motor differances by year ...
- Aftermarket IRS cv shafts anyone?
- aluminum driveshaft for 01' cobra?
- Comparison of tune on blown 4V's...
- 03 pumps on 2001 cobra pump assembly
- 3650 swap parts?
- BBK CAI vs. JLT CAI
- should I swap my rearend for a straight axle?
- looking for...
- 01 Cobra threw a P0190 code.. need advice
- 99 Cobra loud ticking/knocking noise
- 2001 Cobra blower Question
- New member with questions.
- 03 cobra cams and springs...how will they do on a turbo car?
- Driveshaft problems
- 03' Cobra Half shafts to 99' Cobra QUESTIONS???
- Puff of smoke on start-up?
- Help me w/ my cam choice.
- In desperate need of...
- finally got to the track again. timeslip inside...
- Differential Swapout
- Intake porting ???
- Question about the TR3650 in my Mach1:
- 4V Rear Spark Plug Tunnels Too Narrow
- Heads update
- Solid-axle swap complete.
- losing oil
- Stock engine life?
- halfshaft upgrade
- 4V Engine Swap
- Need Help With Dohc Chain Tensioner Guide
- mock-up photos of an intake nobody uses
- Need Help With Surge Tank Mounting
- New Project: 4.6L Stroker (302CI) Supercharged / Need build suggestions and info
- 01 Cobra Kenne Bell Installation Questions