- Hellion Power systems Turbo deal
- P0172code NEED HELP ! !
- Ported 03 heads + Fr500 kit ????
- Locating machine shop
- Anyone successfully fitted the Cobra lid to the Aviator lower intake?
- 04 Cobra short block into my 01... what do I need?
- Is this long block worth the $
- N/A cams vs Blower cams
- Need help to get into the 12's from a 13.22 on factory stock motor
- Should I go with a Predator for a tune?
- 4V Turbo Cobra Cam Degree Settings ?
- If you know about t-45's and self adjusting clutch PLEASE help
- 96 GT Harness/99 Cobra Motor problems
- Car Smokes on Decel
- Sullivan Intake Install Question
- clutch fork Question
- 5.4 Al Ford GT block into my 01 Snake... what mods to make to block?
- Evans System Help
- Drumming vibration in '97
- Longtubes...yes or no?
- Kenne-bell customer service
- What Can I Do To Save My Motor!!?? Please Help Me!
- What else do i need?
- Valve Seal Installation ?
- 98 Cobra catastrophic engine failure ???
- Compression problem on a 4v
- 1 more question.
- best cams for lincoln?
- thanks to MT1083
- Aviator pump???????
- sullivan intake install, "day 2"
- Those with Bassani Mids...
- Any Lincoln come with C heads????
- Need Fuel System Advice
- A few pictures of the new motor to share
- Two Step
- Do I need anything else for a FR500 Swap?
- is the F6TE crank in a 5spd Mach 1 forged?
- Adding coolant question
- 03 cobra cams any good for turbo?
- '04 cobra supercharger on a 97 cobra?
- help with my lame skills
- Cams?
- Best Performance Shop in NC?
- Cyl 8 now at 180
- replacing head gaskets help
- Alcohol Injection
- Anyone swap an explorer axle?
- Various Stock Cam Specs
- 03 cobra cams & 01 Cobra cams
- screamin demon coil packs
- Threw a code tonight!
- To Stroke or not to Stroke that is the question
- Different spark plug gap/aftermarket plugs for more power???
- AMF's Mr. Freeze, or Snow Performance Boost Cooler????
- Header install..frustrating!!!!!
- 96-98 cobra brakes
- Remove Air pump?
- shaky motor at idle need help
- 03-04 Cobra MM strut tower brace?
- Blown Head Gasket.......??
- Sullivan Intake Install, "11th hour"
- exhaust manifold bolt
- Polished Intake
- 15s on rear of mach
- Blown Head Gasket.......??
- Help, my brakes are pulling hard to the right!
- Can I run 100% water w/ Redline water wetter..
- Brake Pads are done....
- Installing Raptor Shift Light in 97 Cobra, Need Help