Couple Vids of my whipple cobra

younggun04 · 06-20-2008, 03:06 AM

Just got the whipple on a couple weeks ago thought i would share...

http://videos.streetfire.net/video/0...CBR_167088.htm

http://videos.streetfire.net/video/0...ing_166205.htm

11ride4life · 06-20-2008, 06:02 AM

Very nice!!

What #'s did you make with the Gen II?

younggun04 · 06-20-2008, 11:23 AM

Quote:

Originally Posted by 11ride4life

Very nice!!

What #'s did you make with the Gen II?

I got my car tuned on a Mustang dyno and made 532/488. The MD I use has been proven 14% lower than the dynojet in our area. My car will be going on a dynojet on the 27th of this month. Hopefully can get close to 600whp

1BADSVT · 06-20-2008, 05:53 PM

my ported eaton made 521 rwhp and 522 rwtq on a mustang dyno, 114 octane 23 degrees of timing 2.76 upper & 2 lb lower and other supporting mods! trust me your car will have no problem geting 600 with the rite tune and boost

SVTkel · 06-22-2008, 09:27 AM

Congrats on the Whipple and some mice video's.

What was your setup before the Whipple and how blown away were you the first time you pinned it?

younggun04 · 06-22-2008, 01:49 PM

Quote:

Originally Posted by 1BADSVT

my ported eaton made 521 rwhp and 522 rwtq on a mustang dyno, 114 octane 23 degrees of timing 2.76 upper & 2 lb lower and other supporting mods! trust me your car will have no problem geting 600 with the rite tune and boost

the mustang dyno here reads very low compared to few numbers i have seen down in the states. Don't know why, but numbers are numbers. My buddy with a simular setup just slightly higher numbers is trapping 126 mph in the 1/4 so I think my car is right where it should be.

Quote:

Originally Posted by SVTkel

Congrats on the Whipple and some mice video's.

What was your setup before the Whipple and how blown away were you the first time you pinned it?

My old setup was a steggy IV with a 2.76 pulley, 60's, BAP, Mafia. Made 494/486 on a dynojet. The first time i pinned the whipple it i gave me a smile

.