With the cylinder wall finish being so critical for ring seal and power would you risk the possibility of a poor hone job by partnering with a machine shop that uses an old non CNC hone machine?

Will f150 2003 pi heads an intake work on my 98 gt both 4.6

I have pi heads an intake from a 2003 f150 will this work on my 98 4.6 gt ?

Have a terminator with very low miles (5000) that has an odd issue. The engine starts ticking at 210F coolant temp (normal operating temp), and only at idle. No tick is heard on cold start, but once the car reaches 210F coolant temp you can hear the tick start, but again only at idle. Give it a...

Looking for reputable machine shop for Procharged forged 4.6 3v stroker & CNC heads. In Savannah, Ga, but willing to ship or travel.