KEVINS
Senior Member
Find latest posts
View ArticlesMini Statistics
- Join Date
- 01-16-2014
- Last Activity
- Today 03:48 PM
- Avatar
Recent Visitors
This page has had 10,286 visits
- Tab Content
- KEVINS's Activity
- Visitor Messages
- About Me
- Video
- My Vehicles
- Activity
-
Older Activity
-
01-08-2021, 07:53 PMWith all respect Ed, I disagree with your recommended direction. I've read that same thought idea for several years before installing my MSPro and...16 replies | 806 view(s)
-
12-23-2020, 11:34 PMYou too Ed! Let's all try and keep the stress down over the holiday's and simply relax and have fun... I have the next two weeks off and the only...6 replies | 478 view(s)
-
11-29-2020, 10:02 PMI'm not sure what those rails look like but on my 2V I hacked off the ends of the rails as much as possible to shorten them then retapped the holes....11 replies | 684 view(s)
-
10-17-2020, 01:56 PMThey are Motorcrafts that I bought from RockAuto when I put the Megasquirt in so I hope these are authentic from RA. They have about 300-500 miles on...66 replies | 2963 view(s)
-
10-16-2020, 09:11 PMAs you know I can't fix what's not broke and fixing electronics that won't act up when I'm diagnosing can be impossible to fix...:( I'm hoping that...66 replies | 2963 view(s)
-
10-16-2020, 06:03 PMFinally some Good News! I received the coils from Matt above (THANK YOU!) and put a few in #5 cylinder and all is well after a few minutes of...66 replies | 2963 view(s)
-
10-13-2020, 11:30 PMA quick thought while laying in bed. What should/can be the cranking dwell be? If 3ms is too long for normal dwell then what about the cranking dwell...66 replies | 2963 view(s)
-
10-12-2020, 10:54 AMYes, I'm measuring the pins of the connector while disconnected from the coil, key on, engine off. Both banks have always shown the same in all...66 replies | 2963 view(s)
-
10-11-2020, 08:33 PMI just probed each coil connector pin to chassis ground and with a freshly charged battery the (+) pin measures 11.5V on Connectors #5, #6 and #7 ...66 replies | 2963 view(s)
-
10-11-2020, 08:08 PMI agree, but I'm not finding any electrical short in the wiring by probing thus the need to physically review each wire.. ks66 replies | 2963 view(s)
-
10-11-2020, 07:39 PMThe actual AF values I don't care about at idle but when one bank used to be on average .3-.4 less than the other bank but now it's on average...66 replies | 2963 view(s)
-
10-11-2020, 04:32 PMActually my tea leaves were pointing to no compression. This makes absolutely no sense but that's where it was leading me. HOWEVER, after speaking...66 replies | 2963 view(s)
-
10-11-2020, 01:23 PMMore info and the path is not looking favorable: 1. Got a thermal gun and checked the temps on all the primary exhaust tubes and #5 is not getting...66 replies | 2963 view(s)
-
10-10-2020, 02:40 PMGot it all back together and there was no change so I swapped out the quadspark module for #5 cylinder and still no change. I know the #5 cylinder...66 replies | 2963 view(s)
-
10-09-2020, 11:54 AMYea, and I think I found it being that pointy solder joint piercing the heat shrink on #5 coil harness. I didn't see if it was on the negative side...66 replies | 2963 view(s)
-
10-09-2020, 08:25 AMI got 10V when probing across both connector pins (+/-) with the Vampire plugged in but 0V with it unplugged. When probing each pin to chassis...66 replies | 2963 view(s)
-
10-09-2020, 07:48 AMJohn and I have been emailing back and forth and the below is his explanation of why I will see voltage across those pins, however, the current is...66 replies | 2963 view(s)
-
10-08-2020, 01:46 PMIt would be interesting to see what ET's it would run with the traction control on. ks59 replies | 14872 view(s)
-
10-07-2020, 09:49 PMI just wet myself...:what: ks59 replies | 14872 view(s)
-
10-07-2020, 02:45 PMLong story. The Vampire has two 8-pin connectors that plug into another PnP harness that has two 8-pin connectors on one end (for the vampire) while...30 replies | 1219 view(s)
-
10-07-2020, 01:46 PMJohn wants me to send a pic of how I'm measuring the connector voltage so I will do that tonight. I also mentioned my findings to Matt but I haven't...30 replies | 1219 view(s)
-
10-06-2020, 08:13 PMI emailed John and explained our concerns so we'll see what he says. If he agrees that there should NOT be voltage it will be easy enough to find...66 replies | 2963 view(s)
-
10-06-2020, 08:07 PMNo clue. When it comes to electrical I just do what I'm told as long as it's explained so a 5 yr old can understand it. My plug gap is only about...30 replies | 1219 view(s)
-
10-06-2020, 07:27 PMThey were at 3ms and Matt said to cut that in half. ks30 replies | 1219 view(s)
-
10-06-2020, 07:09 PMI did the MS coil test and everything worked as expected with the Vampire connected and without it connected. So I started chasing the #5 coil...66 replies | 2963 view(s)
-
10-06-2020, 06:00 PMTechnically the Vampire isn't activated until it hears knock which is why it can be disconnected and the car will run fine. Once it hear knock then...66 replies | 2963 view(s)
-
10-06-2020, 03:32 PMThat's what I thought and that's why I figured any coil that was plugged into #5 harness was burning up. Not to mention the one coil that melted due...66 replies | 2963 view(s)
-
10-06-2020, 02:46 PMI was testing across the two pins on the harness connector with key on (no coil attached). I didn't think there should be any voltage as Ed...66 replies | 2963 view(s)
-
10-06-2020, 11:41 AMI didn't measure anything afterwards. Initially I was measuring across the pins on the connectors expecting 0V but I got 9-10V with the knock...66 replies | 2963 view(s)
-
10-06-2020, 10:06 AMI will also send back the electronics to be tested just to make sure nothing happened to them then put it all back together and it will be fine...66 replies | 2963 view(s)
1 Visitor Messages
About KEVINS
Basic Information
About KEVINS
- Receive Special Offers from Supporting Vendors via Email:
- Yes
Signature
http://www.baselinesuspensions.com/Projects/balrog.htm
2002 2V, Twin 60's, Pi Heads, E85
902HP @ 32psi, Silver Fox 4R70, Full Length 2.5" Exhaust, Mustang Dyno.
2002 2V, Twin 60's, Pi Heads, E85
902HP @ 32psi, Silver Fox 4R70, Full Length 2.5" Exhaust, Mustang Dyno.
Statistics
Total Posts
- Total Posts
- 459
- Posts Per Day
- 0.18
Visitor Messages
- Total Messages
- 1
- Most Recent Message
- 05-09-2015 12:00 PM
General Information
- Last Activity
- Today 03:48 PM
- Join Date
- 01-16-2014
- Referrals
- 0
- No Listings in the database at this time.
Activity Information
Points
|
7 Achievements
Reached 300 posts! phew
Achievement Earned on 08-30-2019 05:30 PM
Reached 250 posts
Achievement Earned on 04-16-2017 10:49 AM
Reached 200 posts
Achievement Earned on 05-19-2016 07:19 PM
Reached 150 posts!
Achievement Earned on 11-11-2015 07:07 PM
Reached 100 posts mark!
Achievement Earned on 03-27-2015 09:51 PM
Posted 50 Posts!
Achievement Earned on 01-25-2015 05:25 PM
Posted 10 posts!
Achievement Earned on 10-16-2014 11:14 PM 0 Awards0 Currently Held Trophies0 Previously Held Trophies |