- Tab Content
- CrucialProspect's Activity
- About Me
- Video
- My Vehicles
- Activity
- Tab Content
-
Older Activity
-
11-15-2020, 02:48 PMSo I’ve figured out I have a 6g alternator, and wanted to see if possible to use it with the Holley hp system. I know a lot of folks run a 1 wire...0 replies | 392 view(s)
-
10-24-2020, 01:21 PMThank you sir, I really appreciate it!2 replies | 508 view(s)
-
10-21-2020, 05:44 AMI’ve seen a bunch of pictures and have vague information on installing a B&M or hurst style gates shifter in the cupholder location, but wanted to...2 replies | 508 view(s)
-
10-16-2020, 08:53 PMCrucialProspect replied to a thread One bank shows rich on WB with slgiht engine vibration in Turbo ModularYou are very welcome, glad you got them and so far all is well. Maybe the solution was 16yo genuine motorcraft coils?66 replies | 2966 view(s)
-
10-11-2020, 06:46 PMCrucialProspect replied to a thread One bank shows rich on WB with slgiht engine vibration in Turbo ModularI’d disregard any readings going from one wire to the other on the connector. I’d be slightly concerned with the lack of full battery voltage on the...66 replies | 2966 view(s)
-
10-09-2020, 12:46 PMCrucialProspect replied to a thread One bank shows rich on WB with slgiht engine vibration in Turbo ModularNice find!66 replies | 2966 view(s)
-
10-09-2020, 08:01 AMCrucialProspect replied to a thread One bank shows rich on WB with slgiht engine vibration in Turbo ModularAnd now we are also confirming the resistance should be closer to .5 rather than the 1+ ohm you are seeing...66 replies | 2966 view(s)
-
10-09-2020, 07:58 AMCrucialProspect replied to a thread One bank shows rich on WB with slgiht engine vibration in Turbo ModularI thought you noticed the opposite, 10v on negative when plugged To the vampire and 0v with it disconnected?66 replies | 2966 view(s)
-
10-07-2020, 02:25 PMAny variation coil to coil would be an alarm in my mindset. Anytime I get a - number, it shows test leads are on the wrong side. Could that be...30 replies | 1220 view(s)
-
10-07-2020, 01:07 PMBy looking at the ms base table, is dwell set at 3ms minimum? If so, as load increases it would increase dwell time, which is no bueno. Like Ed said...30 replies | 1220 view(s)
-
10-06-2020, 07:34 PMCrucialProspect replied to a thread One bank shows rich on WB with slgiht engine vibration in Turbo ModularSomething on the trigger wire is grounding out causing it to be a completed circuit. Now that it’s “fixed” it’s gonna be pretty darn hard to find...66 replies | 2966 view(s)
-
10-06-2020, 07:33 PMMy only concern at this point is if it was able to put out enough spark, with the correlating gap you are running, to keep that beast firing on a...30 replies | 1220 view(s)
-
10-06-2020, 06:24 PMCrucialProspect replied to a thread One bank shows rich on WB with slgiht engine vibration in Turbo ModularExactly Ed. It shouldn’t show a completed circuit at all.66 replies | 2966 view(s)
-
10-06-2020, 04:19 PMCrucialProspect replied to a thread One bank shows rich on WB with slgiht engine vibration in Turbo ModularLast time I tried to find a short I decided to gut every wire on the car and go with a Holley system! I’d definitely check signal across both...66 replies | 2966 view(s)
-
10-06-2020, 03:21 PMCrucialProspect replied to a thread One bank shows rich on WB with slgiht engine vibration in Turbo ModularAnd to add to that... if you are getting a completed circuit at all times.... it’s killing your coils. Basically it’s running non-stop, cooking. Just...66 replies | 2966 view(s)
-
10-06-2020, 03:18 PMCrucialProspect replied to a thread One bank shows rich on WB with slgiht engine vibration in Turbo ModularSomething doesn’t seem right, the one wire should get 12 volts while key is on and the other test lead is grounded. This is an open circuit that...66 replies | 2966 view(s)
-
10-06-2020, 02:01 PMI thought the longest you could set the dwell on the factory coils was 3ms. That seems a bit hot for everyday like I think Ed is suggesting. Dwell is...30 replies | 1220 view(s)
-
10-06-2020, 01:42 PMCrucialProspect replied to a thread One bank shows rich on WB with slgiht engine vibration in Turbo ModularOne aide should show 12v with key on, test ground to it. The other would be hard to test unless you disable fuel and hook up a noid light, it will...66 replies | 2966 view(s)
-
10-06-2020, 11:26 AMCrucialProspect replied to a thread One bank shows rich on WB with slgiht engine vibration in Turbo ModularOne of us will have a running car soon! I’d still like to know for a definitive answer what the coil windings resistance in the primary side...66 replies | 2966 view(s)
-
10-06-2020, 10:02 AMCrucialProspect replied to a thread One bank shows rich on WB with slgiht engine vibration in Turbo ModularAh, gotcha. And of course now that it’s “fixed” it won’t show anything.66 replies | 2966 view(s)
-
10-06-2020, 08:39 AMI’ll send you all 8 of mine if you promise not to torch them! 😂 In all honesty though, I’ve checked the primary and secondary resistance...30 replies | 1220 view(s)
-
10-06-2020, 08:25 AMCrucialProspect replied to a thread One bank shows rich on WB with slgiht engine vibration in Turbo ModularNot sure how your wiring is done, but would it be as simple as to check continuity of the 12v power side of the coil as well as the trigger side?...66 replies | 2966 view(s)
-
10-03-2020, 03:52 AMAlready have everything for the Holley. Main reason I went with that system is to get rid of the previously hacked factory wire job that is hopefully...3 replies | 229 view(s)
-
10-02-2020, 10:14 PMMade a hella pass tonight in the car, until it shut off. Had to tow it back to the trailer and that’s where I found the under hood fuse 26 blown....3 replies | 229 view(s)
-
09-13-2020, 06:55 PMAs for a quick fix for this weekends excursions, I closed up the gap to .020.12 replies | 843 view(s)
-
09-13-2020, 06:54 PMIs the factory pcm capable of running either of those coils? Just interesting that there is very little plug and play coils, even the msd’s don’t...12 replies | 843 view(s)
-
09-13-2020, 05:11 PMStock pcm still, I do favor the “safer” a/f ratio. Like I said, ignition is lacking for sure, I saw the ign-1 coils putting out slightly more voltage...12 replies | 843 view(s)
-
09-13-2020, 04:04 AMUnder load I’m seeing 10.8-11.2 on a Bosch sensor that’s a few days old.12 replies | 843 view(s)
-
09-13-2020, 03:34 AMLeaded 114, we are close to 12.5 on a/fr12 replies | 843 view(s)
-
09-12-2020, 07:31 PMThe ground strap seems to show it’s in the correct heat range, yes it’s a bit fat on the mixture, maybe just close up gap to .027 and see if she...12 replies | 843 view(s)
About CrucialProspect
Basic Information
Statistics
Total Posts
- Total Posts
- 228
- Posts Per Day
- 0.51
General Information
- Last Activity
- 01-11-2021 07:08 AM
- Join Date
- 10-27-2019
- Referrals
- 0
- No Listings in the database at this time.
1 Achievements![]()
Posted 10 posts!
Achievement Earned on 10-29-2019 05:02 AM 0 Awards0 Currently Held Trophies0 Previously Held Trophies |