Search Results - Mustang Forums and Ford Performance Forums at ModularFords

Search:

Type: Posts; User: Foxandthefish; Keyword(s):

Search: Search took 0.01 seconds.

  1. Replies
    6
    Views
    807

    Wish I had some insight for you, Im still trying...

    Wish I had some insight for you, Im still trying to learn these Mod motors. But other than when I switched on my 5.3 from a batmowheel 83 to twin S366s lb for lb boost the twins made more power.
  2. Replies
    5
    Views
    402

    Yes Im testing the waters in a sense, but only...

    Yes Im testing the waters in a sense, but only due lack of knowledge. My brain has been filled with LS stuff for the last 6 years and two cars here lately have caught my eyes. John Mihovitz, and...
  3. Well I was okay with MS3PRO until yesterday. Mine...

    Well I was okay with MS3PRO until yesterday. Mine took a **** AGAIN yesterday while on the dyno with my other car. My cousin has had nothing but bad luck, failing ECU boards and problems with the...
  4. Replies
    5
    Views
    402

    Even if I do ARP main studs, leave the mains...

    Even if I do ARP main studs, leave the mains alone? Only thing I have done with the B heads is buy a intake manifold. I wasn't planning to pump a lot of money into the heads. Pretty much run stock...
  5. Replies
    6
    Views
    461

    Id rather pay for new stock bore pistons and a...

    Id rather pay for new stock bore pistons and a torque plate hone over having the block bored to fit these and keep the cylinder wall thickness. Its a turbo car so I doubt I would see any HP gain from...
  6. Replies
    6
    Views
    461

    The Diamonds .020 over and come with the whole...

    The Diamonds .020 over and come with the whole rotating assembly but had planned on new pistons to try to retain stock bore. Ill definitely look at those and likely get a set. Seems from the reading...
  7. Replies
    5
    Views
    402

    Help with my turbo build.

    So heres a complete breakdown of the whole 4.6 build I have going on at the moment. Its a 95 Teksid block, Kellogg crank, Scat rods, Diamond pistons (likely to change), B heads, 97 Cobra intake and...
  8. Stand alone ECU options and suggestions

    I have a 95 teksid long block from a Mark 8 and stock ECU harness. I see a lot of the Holley systems are for the 99+ 4.6 DOHC setups. Whats the major differnce between the two that would keep me from...
  9. Replies
    6
    Views
    461

    That's good to know. Trying to cram as much info...

    That's good to know. Trying to cram as much info into my brain as I can next few months before I start into this 4.6 DOHC. This Sat I will be picking up a Kellogg crank with Scat rods and Diamond...
  10. Replies
    6
    Views
    461

    Oil pump and oil system

    What's everyone doing for oil pump, pan, and RPM on 4.6 mod motors? New to this DOHC platform and with my LS stuff it starts cavitation at high RPM. Is there any similar issues with mod motors? I'm...
  11. Replies
    0
    Views
    145

    New member, new to mod motors

    So as the post says new here and new to the mod motors. Recently picked up a 88 4 cylinder hatch that will eventually look like a 86 which ha always been a favorite of mine. So post of this build, I...
Results 1 to 11 of 11