Search Results - Mustang Forums and Ford Performance Forums at ModularFords

Search:

Type: Posts; User: stanghank; Keyword(s):

Page 1 of 3 1 2 3

Search: Search took 0.02 seconds.

  1. Replies
    0
    Views
    295

    Power steering pump on my 06 GT

    I'm having a problem with my power steering pump. When I get into high RPM's the pump goes out. If I stay below 5,500 rpms it is fine . I do time trials at Willow Springs Road Course. Its 9 turns...
  2. Swaped my 2006 GT from Auto to 5 speed and having problems

    I have put a trans from a 2007 mustang GT into my 2006 GT. I purchased the C/C and clutch start switch harness and installed it. I made my own reverse lite Harness which works. I have downloaded a...
  3. Replies
    3
    Views
    728

    Nope. Wrong off set.

    Nope. Wrong off set.
  4. Replies
    8
    Views
    2,314

    I just went through the same concern with my sway...

    I just went through the same concern with my sway bar. Baught a used 99 sway bar and took it to a muffler shop and had it bent as was suggested on this site. When i tryed to install it, the brkts...
  5. Replies
    31
    Views
    2,937

    Is the rearend just hanging down? I had the same...

    Is the rearend just hanging down? I had the same problem with my 87 when i changed it to the T45. I am using a 96 froont cross member also. I jacked the rearend up and put it on jack stands. I let it...
  6. Replies
    21
    Views
    5,480

    I did the same thing with my swap and it set way...

    I did the same thing with my swap and it set way to far to the front. I put a K member in it frm a 96 V6 amd it set everything whereit belonged. I didnt have to make a longerdrivesaft or anything.
  7. Replies
    2
    Views
    492

    Thanks for your help.

    Thanks for your help.
  8. Replies
    138
    Views
    44,429

    I am in need of a wiring diagram for a 2002...

    I am in need of a wiring diagram for a 2002 instrament cluster. Thnk you for your help.
  9. Replies
    1
    Views
    1,117

    Take it to a good mechanic and have it checked...

    Take it to a good mechanic and have it checked out. Has the car ever been in an accident?
  10. Replies
    0
    Views
    852

    Changed from Auto trans to T5

    I found a T5 trans from a 3.8 V6 mustang in St. Louis for 100.00 so i baught it. It is infact a World class T5. The tag on the side showed it to be a reman. I took it apart and it looked like new so...
  11. Replies
    2
    Views
    492

    2002 instrament cluster

    Need wiring diagram for 2002 instrament cluster. Im adding it to a 1995 dash. Need help. Thank you.:good:
  12. Replies
    1
    Views
    524

    Question about flywheels

    Since the 94 and newer 3.8V6 trans and bellhousing is the same as the 5.0, Will the flywheel from the 3.8 work on the 5.0 ?
  13. Replies
    18
    Views
    2,142

    use the hydroboost and the prop. valve that goes...

    use the hydroboost and the prop. valve that goes with it. That valve is set for 4 wheel disk brks.
  14. Replies
    2
    Views
    922

    Yes you would have to switch over to the...

    Yes you would have to switch over to the Hydroboost. Its a much better system anyhow.
  15. Replies
    5
    Views
    1,457

    You can get a set of spendals off the 95-04...

    You can get a set of spendals off the 95-04 mustang with rotors and calipers. Install 94 lower ball joints in you lower controll arms and it works great.
    Get the rear axles, rotors, calipers,...
  16. Replies
    16
    Views
    2,137

    Since you have a 2000 mustang, you can use the 99...

    Since you have a 2000 mustang, you can use the 99 and up EEC harness. When you change the computer, you will need to get the PATS reset to it. You can either add a Aftermarket Tach or replace the...
  17. Replies
    14
    Views
    4,074

    Got it repainted and looks a lot better. I had...

    Got it repainted and looks a lot better. I had them leave the stripe off the hood. The colors flip a lot better now. Will post some pictures when i get it cleaned up. Still havnt done anything to...
  18. Replies
    14
    Views
    1,695

    Which EEC harness are you using?

    Which EEC harness are you using?
  19. Replies
    3
    Views
    636

    If your harness isnt that bad, You should just...

    If your harness isnt that bad, You should just repair it. Save the money for other parts you may need. The CPO's are the way to go.
  20. Replies
    16
    Views
    2,137

    I would use the 99 heads and soforth if you can...

    I would use the 99 heads and soforth if you can get them. If you can get the front cover for the 99, I would use that also. You have a lot more parts options with them. Yes you can use the cobra...
  21. Thread: Wiring issue

    by stanghank
    Replies
    11
    Views
    1,168

    the red/lt.green wire connects to the brown/pink...

    the red/lt.green wire connects to the brown/pink wire from the ign.switch. It runs to the charging indicator in the dash and to the alternator.
    The grounds are under the dash connected next to the...
  22. Replies
    16
    Views
    2,137

    The computer harness has to go but everything...

    The computer harness has to go but everything ealse will work. Take the V6 cluster out and replace ir with the V8 cluster and your good to go. The V6 cross member is the same as the V8 cross member....
  23. Replies
    1
    Views
    2,773

    Use the fox steering rack. The sn95 tie rod ends...

    Use the fox steering rack. The sn95 tie rod ends are to wide. The fox rack will work just fine.
    The fuel lines will work from the fox body. Change the fuel pump to a larger one.
    The fox heater...
  24. Replies
    38
    Views
    2,935

    at the back of the booster, where it mounts to...

    at the back of the booster, where it mounts to the firewall. There is a bleeder valve on the top. Bleed the power steering from there.
  25. Thread: Busy weekend

    by stanghank
    Replies
    8
    Views
    1,426

    Fantastic job on the engine bay !!

    Fantastic job on the engine bay !!
  26. Replies
    14
    Views
    4,074

    Thanks for the complament on the paint. It does...

    Thanks for the complament on the paint. It does look nice but i am going to have the lower half repainted. The doors dont match like they should. We think they used the wrong base coat and it changed...
  27. Replies
    14
    Views
    4,074

    Yes i am going to get a set of FR500 wheels....

    Yes i am going to get a set of FR500 wheels. 10.5" with 315/30 on the back and 9" with 275/40 on the front. The springs and struts/shocks will have to waite untill i can decide what i want to do...
  28. Replies
    14
    Views
    4,074

    Yes it is. Ford wont sell the paint unless you...

    Yes it is. Ford wont sell the paint unless you have wrecked your cobra and then they have to inspect the car to verafy the amount of paint you need and thats all you get. With the dupont paint, I pay...
  29. Replies
    3
    Views
    3,323

    Did they ever find your Saleen? Sorry to hear it...

    Did they ever find your Saleen? Sorry to hear it got stollen.:mad2:
  30. Replies
    5
    Views
    1,107

    The door panels will have to have the chrome...

    The door panels will have to have the chrome trimed at the upper front corners and they will work great.
  31. Replies
    14
    Views
    4,074

    more pictures

    Its back together so now its time find some black seats and do some mods on the drivetrain
  32. Replies
    14
    Views
    4,074

    95 Mustang Gt

    More pictures
  33. Replies
    14
    Views
    4,074

    95 Gt

    More pictures
  34. Replies
    14
    Views
    4,074

    95 GT repaint

    I picked this 95 up in Jan. Just got time to start the work on it. I have everything on the interior changed from tan to black. Had to replace the rt. front apron. We painted the car Pure Jade by...
  35. Replies
    10
    Views
    1,367

    steering

    The shaft should pull out far enough to make the connection. Was the 91 that you pulled the collumn out of in a front end collision?
  36. Replies
    10
    Views
    1,367

    Are you using the steering collum from the 98. If...

    Are you using the steering collum from the 98. If your not, you will have a problem getting the two to connect. The inner tie rods are also to long for a fox body unless your using 95 up lower...
  37. Replies
    19
    Views
    2,734

    You can actually pick up the tach signal at the...

    You can actually pick up the tach signal at the instrament cluster wirring. You can also pick up the other wires for the oil and temp there.
  38. Replies
    345
    Views
    59,236

    Hi Erick and Lisa. First of all I want to thank...

    Hi Erick and Lisa. First of all I want to thank you for a site that is very informative on this type of swaps. It has helped me a great deal. Im sure that there are a lot of people like myself that...
  39. Replies
    138
    Views
    44,429

    Would it be possible to get the pin out for a 87...

    Would it be possible to get the pin out for a 87 mustang ign. switch?:tip:
  40. Replies
    7
    Views
    1,708

    Several people on here have had the same concern...

    Several people on here have had the same concern with the sway bar. They have talked about doing everything from taking the bar to have it bent on each end to having custome ones made. Take a look at...
Results 1 to 40 of 100
Page 1 of 3 1 2 3