Mustang and Ford Performance Forums banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-6 of 7 Results
  1. 1996-2001 Cobra / 2003-2004 Mach 1 Classifieds
    Steel flywheel from 8 bolt crank 03 Mach 1 - shows Nodular Cobra on the flywheel. This flywheel was from the forged crank 4.6 engine in Cobra's/Mach 5 speeds Make me an offer
  2. Engine Parts
    hey guys these are both in very good condition and have right at 10k on them both tore the engine down to prep for more power so ill take 60 plus shipping for the crank and 50 plus shipping for the flywheel pm me if you are interested in either or both here is a pic of the flywheel and ill post...
  3. Drivetrain Parts
    PRW SFI approved billet steel flywheel out of a 2006 Mustang GT. Less than one season on this flywheel and absolutely no track time. Pulled to replace with new 8 bolt setup. Asking $100 and will throw in the Ram Power Grip for another $25.
  4. Drivetrain Parts
    Spec Billet Steel 8 Bolt out of my 00 GT (has forged bottom end w/ 8 bolt crank). It does have some rust and wear, but not nearly as many hot spots as I thought it would. HAS NEVER SEEN DRAG RACING, just street driving. Under 12k miles on it. Removable insert as well. $150 SHIPPED
  5. Drivetrain Parts
    I have for sale one used 11" LFP/Centerforce 26 Spline Clutch Kit with an 8 bolt LFP/Fidanza Flywheel, NIB Centerforce T.O.B. and a NIB Ford roller pilot bearing. Clutch, pressure plate and flywheel have about 500 miles on them. The T.O.B. and Pilot Bearing are brand new. The serial number on...
  6. Engine Parts
    NO REASONABLE OFFER REFUSED I have a 6 bolt FRPP billet flywheel with about 10k mi (has some slight surface rust), I think late 01-04 GTs have 6 bolt crank shafts - Goes for $250 at Summit asking $175 or best offer. Had to replace with an 8 bolt flywheel because I put in a cobra crank shaft in...
1-6 of 7 Results