Search Results for ‘tko’

sold!!

Transmission shifted great up until couple months ago. Replaced transmission with new and still had same high RPM shifting issue. Took back apart and found Pilot bearing bad and piece of bearing between flywheel/disc $350 or trade for ?? You can call/text 765-413-7725 or email me...

This piece is brand new and never mounted on a tranny, esp since i bought the wrong short throw.. They are 189 new before tax and shipping and all that. I am selling this for 150 shipped anywhere in the US.. BRAND NEW.. Only out of box for pics

I was kinda curious if anyone here is running a TKO600 behind their 2v? What all did you need and where did you get it from? i am taking it out of my 95gt and putting it into my project.. Everywhere i look i can only find bellhousings and such for 302/351s.. So what did you do to make it work?

Tremec Aluminum Bellhousing for mounting a Tremec 3550, TKO, TKO 500, or TKO 600 to a modular motor. Came out of my friend's 99 GT with 5.4/TKO 600 setup, only removed because he swapped to an auto. No cracks. Has a starter bolt broken off in it, but has a good bit sticking out, shouldnt be too...

I have a 3550 TKO-II that I am putting up for sale. This is a 26 spine input, 31 spine output. Its low mileage tranny used only at track, has about 3K on it. I have a Steeda Tri-Ax, the drive shaft with 31 spine yoke, and I have a lakewood bell that mounts up to a 4.6/5.4. I am going 6 speed...

Tremec 3550 that was just gone through by Promotion, has 26 Spline Input Shaft (it's basically a TKO now), only 512 miles on it! Transmission has NOT been to the drag strip or had any sort of power adder on it, was behind an n/a 308 in a sub 3000 pound car. Still being broken in and has only...