Mustang and Ford Performance Forums banner

Hellion with K Member brace and torque limiters?

1K views 3 replies 2 participants last post by  michael.konor 
#1 · (Edited)
Anyone running a K Member brace with the torque limiters? I ordered it from PMP then saw a post about it not fitting with another brand of turbo. Now I am wondering if it will fit with the Hellion kit.

Oh, the brace is the CHE 4 point.
Thanks
 
#2 ·
When I installed the Hellion turbo onto my convertible, I had to remove the K-Member brace in order to get the exhaust pipe going to the turbo mounted. After getting everything installed, I wasn't able to put it back on since it would have cut through about 3/4" of the hellion pipe.

I did see a way to create a modifying plate that would raise the K-Member brace and allow me to mount it back up. Did some initial work, but had to come over here to the sandbox a few weeks early and didn't get a chance to finish it.
 
#3 ·
Thanks, that is what I was worried about. Maybe I can get with a fab shop and come up with something. Guess I'll see when the brace gets here.
 
#4 ·
Wouldn't be that hard to have something fabricated at all.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top