Mustang and Ford Performance Forums banner

FS/FT 4.6l Nitrous/Blower Stroker

3K views 1 reply 1 participant last post by  pcsrvcs 
#1 ·
CUSTOM 4.6l Stroker Shortblock

Built BY
Houston Performance

- Freshly Machined -

4.6 2v Windsor Block
Torque Plate Bored & Honed
Balanced and Blue Printed
FRPP Hi-Volume Oil Pump
JE Forged Custom Stroker (.030 Over) spherical -2.75 dish pistons
Federal Mogul race bearings
File fit JE Ring Set
Eagle H-Beam forged rods
Forged HP Stroker crank
ARP Main Studs
ARP Rod Bolts

This should be 8.8:1 compression with a 2v head on it.
And it should be low 8's with a 4v head on it.

The motor is built for Nitrous/Blower application and can handle just about any power level you throw at it.
The only thing this motor is lacking are Billet Rods which are needed for 1000hp.

$4000.00 - O.B.O.
Would like to trade for KB 2.6L KIT for 4.6L-2v

Robert
(580) 223-2527

Pictures
 
See less See more
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top