Mustang and Ford Performance Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
87 Posts
Discussion Starter · #1 ·
Not sure where to post this and may be a dumb question. I have a 2012 5.0 coyote I know the flywheels interchange with other mod motors but clutch and pressure plate only have a 1000 miles on them. Can I use the clutch disc from a 2008 mustang gt which would give me an 11 inch disc with the 10 spline count I need to run the 1998 cobra 5 speed I'm running behind it? Pretty sure tranny is a t-45
 

·
Registered
Joined
·
87 Posts
Discussion Starter · #2 ·
Found this from the march 2011 issue of 5.0mustang and super fords mag. http://www.mustang50magazine.com/te...ford_mustang_gt_50_coyote_engine/viewall.html

As with this display engine, the Coyote development engines we've seen to date wear flexplates for automatic transmissions. The manual applications get a dual-mass flywheel to dampen a driveline rattle and use a higher-torque rated version of the 280mm clutch from the Three-Valve 4.6.

Read more: http://www.mustang50magazine.com/te...t_50_coyote_engine/viewall.html#ixzz2N07Xl9mY
 
1 - 2 of 2 Posts
Top