Mustang and Ford Performance Forums banner

Caster/Camber install VIDEO

1K views 1 reply 2 participants last post by  BlueScreen 
#1 ·
Here is my latest DIY video. Check out my channel and subscribe!
These are caster/camber plates- very necessary for aligning your car when you lower it or want to have more flexibility for setting your alignment for the track
 
#2 ·
Very nice video, I watched it all. I did this back in 2013 on my 97 GT, except I also added coil-over in the front at the same time.

How was the alignment after everything was done ? My car was at stock height, and to get camber to factory spec, I had to adjust the camber to the full minimum. It's not much of a problem, but I expected to be able to remove some camber, especially if later on I decide to drop the car.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top