SC pulley dimensions for diy fella

+ Reply to Thread
Results 1 to 8 of 8
  1. #1

    Default SC pulley dimensions for diy fella

    I'm asking for dimensions from 6 rib belt to 8 rib. I'm modeling one piece pulley to be bolted on stock damper, and I need measures how long it must be. I know there is ready versions, but my belt drive will be custom, and I have suitable piece of aluminium for this. I'm still missing few pieces, I can't install my Eaton for measuring myself.
    Name:  pulley.jpg
Views: 129
Size:  39.0 KB

  2. Remove Advertisements
    ModularFords.com
    Advertisements
     

  3. #2
    Senior Member Array soap's Avatar
    Join Date
    Feb 2003
    Location
    MI
    Posts
    2,914

    Default

    What distance are you looking for? Between face of outer ribs? Center to center? etc?

    --Joe

  4. #3

    Default

    something than easiest to measure accurately. Best would be measure from bottom of outermost ribs. I have extra damper that I can use during making. I have extra belts too, so belt edge to belt edge could be doable.
    Name:  pulley2.jpg
Views: 112
Size:  24.4 KB
    Last edited by FinnCobra; 03-06-2018 at 08:02 AM.

  5. Remove Advertisements
    ModularFords.com
    Advertisements
     

  6. #4
    Senior Member Array soap's Avatar
    Join Date
    Feb 2003
    Location
    MI
    Posts
    2,914

    Default

    If you don't get someone else to respond sooner, I'll get you a measurement tonight when I get home from work.

    --Joe

  7. #5
    Senior Member Array soap's Avatar
    Join Date
    Feb 2003
    Location
    MI
    Posts
    2,914

    Default

    I am getting about 1.800" between belts or 1.600" between outter edge of 6 rib pulley and inner edge of 8 rib pulley. Hope this helps some.

  8. #6

    Default

    Thanks for your help. Belt distance is better, because I have 2 different width dampers according to weight.
    Last edited by FinnCobra; 03-07-2018 at 12:46 AM.

  9. #7

    Default

    I got another answer too, but there is difference, he got 1.69" between belts ?

  10. #8
    Senior Member Array soap's Avatar
    Join Date
    Feb 2003
    Location
    MI
    Posts
    2,914

    Default

    Probably due to different pulley setups and different belts. I'm using an Innovators West damper with Metco ring and not all 6/8 rib belts are exactly the same width. A tenth of an inch isn't much variation.

    --Joe

  11. Remove Advertisements
    ModularFords.com
    Advertisements
     

+ Reply to Thread

Similar Threads

  1. Replies: 7
    Last Post: 05-31-2013, 12:31 PM
  2. new fella to the forum
    By McLuvin01 in forum New Member Introductions
    Replies: 2
    Last Post: 11-18-2012, 09:04 AM
  3. waddup fella's
    By stangfreak in forum D'Agostino Racing
    Replies: 14
    Last Post: 05-02-2008, 06:57 PM
  4. Calculating boost psi with upper and lower pulley dimensions?
    By 4sdvenom in forum 2003 - 2004 SVT Mustang Cobra
    Replies: 8
    Last Post: 03-16-2006, 04:26 PM

Tags for this Thread