+ Reply to Thread
Results 1 to 4 of 4
03-02-2019, 10:03 PM #1
Lowering springs with IRS install video
Here is my video I wanted to share on installing front and rear lowering springs.
03-05-2019, 06:32 PM #2
I used a spring compressor to remove the rear IRS springs. Seems like the easiest way to do it.
Then I installed a Maximum motorsports coil over kit.
The front colt springs are super easy to swap out: place a jack under the control arm with the knuckle, sway bar link and brakes disconnected, slowly lower the jack and the springs pop right out.
03-06-2019, 12:15 AM #3
As for the front springs, did you watch the video? That’s the same process I already explained in the video
06-28-2019, 09:57 AM #4
- Join Date
- Jun 2016
I had such a hard time doing this and was so determined to not mess with the irs subframe. I compressed the rear springs somehow with the center compressor and a pipe extension....
then compressed the new springs with the same type or compressor.
then I secured the compressed spring with 8 metal band clamps...installed it...compressed it in place by jacking the lca...then cut the band clamps with tin snips...
I was very foolish and very lucky I was..
I am a lot more patient and tend to mull things over more these days..
good video!!! thanks!!
By XSELLR8 in forum 2003 - 2004 SVT Mustang CobraReplies: 0Last Post: 03-02-2019, 10:01 PM
By scarface in forum Suspension PartsReplies: 0Last Post: 05-01-2008, 03:28 PM
By 1radtech in forum 2003 - 2004 SVT Mustang CobraReplies: 1Last Post: 02-16-2005, 09:05 PM