Mustang and Ford Performance Forums banner

#5 full flange thrust bearing question

980 views 1 reply 2 participants last post by  eschaider 
#1 · (Edited)
Putting the motor together and ordered a set of each King MB5281SI and King MB5219SI

Am I suppose to use both the upper and lower #5 flange bearing from the 5219 set, or just the upper from 5219 and the lower from the 5281?

I noticed the one lower from the 5219 set has the tang on the wrong side and wasn't sure if i need to grind a small notch for the tang or use the 5281 lower which has the tang in the correct spot.
 
#2 ·
Just use the #5 upper from the 5219 set to replace the #5 erector set upper in the 5281 set. Do not, repeat, do not use the #5 lower or for that matter any other bearing out of the 5219 set — they are all throw aways sadly.


Ed
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top