3.4 Whipple Coolant Pipe Clearance

+ Reply to Thread
Results 1 to 9 of 9
  1. #1
    Member Array partzman's Avatar
    Join Date
    Mar 2016
    Location
    Youngsville NC
    Posts
    49

    Default 3.4 Whipple Coolant Pipe Clearance

    Name:  crossoverpipe.jpg
Views: 75
Size:  57.5 KB
    Pretty clear issue. What should I do to help with this? I feel like I am missing something obvious. Its a 3.4 Crusher kit. I know they sell delete kits but I also know people have run stock coolant pipes. Thanks for the help.

  2. Remove Advertisements
    ModularFords.com
    Advertisements
     

  3. #2

    Default

    Clearance the blower front case. The amount of aluminum you need to remove is very small and does not have a potential for breaking through to the oil in the front case. You can also minimize the amount of clearancing on the blower case by filing the edge of the coolant plug a bit for additional clearance.

    Ed

  4. #3
    Member Array partzman's Avatar
    Join Date
    Mar 2016
    Location
    Youngsville NC
    Posts
    49

    Default

    Thanks Ed. I'll give it a quick zip with the Dremel. Lightly of course! After this its time to run fuel lines and get a tune for the MS3.

  5. Remove Advertisements
    ModularFords.com
    Advertisements
     

  6. #4

    Default

    Yep, exactly as Ed said.
    That's how I did a friend's 3.4 Whipple Crusher install. Went so far as to grind a small bevel all the way around the coolant plug to help with removal.

    Ken

  7. #5

    Default

    No need to Dremel the front case. On Ebay they sell a stainless plug that has a 1/8 npt fitting in the center on it. Replace the factory plug with the new one. Then you remove the 1/8 npt fitting to bleed / fill the coolant. Worked perfect on my 3.4.

    Here is a link:

    https://www.ebay.com/itm/96-04-Cobra...-/301201015551

  8. #6
    Member Array partzman's Avatar
    Join Date
    Mar 2016
    Location
    Youngsville NC
    Posts
    49

    Default

    I already had clearanced the case just a touch, but my crossover plug is gross and difficult to remove. I think I might just pick up the one you are talking about just for ease of maintenance. Getting all the air out of the coolant system can be a bear with this motor.

  9. #7
    Member Array partzman's Avatar
    Join Date
    Mar 2016
    Location
    Youngsville NC
    Posts
    49

    Default

    Almost done. Trying to figure out the passenger side fuel rail feed. Its a tight fit underneath the elbow. Excuse the gross engine bay.Name:  scpic.jpg
Views: 37
Size:  102.0 KB

  10. #8

    Default

    Quote Originally Posted by partzman View Post
    Almost done. Trying to figure out the passenger side fuel rail feed. Its a tight fit underneath the elbow. Excuse the gross engine bay.Name:  scpic.jpg
Views: 37
Size:  102.0 KB
    Just feed it from the front.

  11. #9
    Member Array partzman's Avatar
    Join Date
    Mar 2016
    Location
    Youngsville NC
    Posts
    49

    Default

    My problem is just getting a fitting in there. I was going to feed it from the back and return out the front. The AN fitting is doable I think just tight. Either way there needs to be a -8AN fitting back there.

  12. Remove Advertisements
    ModularFords.com
    Advertisements
     

+ Reply to Thread