Mustang and Ford Performance Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
112 Posts
Discussion Starter · #1 ·
Just wanted to bounce this off you guys.... When I had the stock Eaton, I purchased a Billet 2.76 to pulley, and the Billet Idler package with 3 - 100mm and 1 - 92 mm. Now that I purchased a KB, it has a 3.5 pulley. I don't think this is going to fit, the pulley and the idler are going to rub against each other (Cause I have a 100mm on top). Do I need to purchase another 92mm Idler, or can I just move the 92 that I currently have, and swap it with the 100m that is on top?

Will this work? What did you guys do? I'm keeping the stock lower pulley. Idea's?

Thanks guys!
Steve :stars:
 
1 - 2 of 2 Posts
Top