[Seraphim38]

I bought an aluminum driveshaft from D&D Performance for the installation of a T56 into my 96 Cobra. I am not sure what years it will fit, but it cost $499 from D&D. This driveshaft was in the car for 500 miles before being removed, so it is in near new condition. $300 shipped, OBO

 

[YAADMAN_GT]

Whats the OD of the DS? Can you measure it and let me know what were your reference points for the measurement?

 

[Seraphim38]

I will measure take measurements and get back to you. I have a box ready for it to ship in.

 

[YAADMAN_GT]

Also, need the spline count, 1310 or 1350 yoke and rear end flange, bolt circle measurement?

 

[Seraphim38]

looks like 28 splines by my count

overall driveshaft length looks to be about 51.75 inches roughly

body of the driveshaft appears to be just under 42 inches. If the rest of the pictures below don't answer your questions let me know. Also, I am sure that D&D Performance can answer questions about this driveshaft since I bought it from them for my 1996 Cobra with a T56 from an 04 Cobra.

 

[YAADMAN_GT]

Not gonna work. My T-56 has a 31 spline output shaft. Thanks for checking!