Mustang and Ford Performance Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
I did valve cover gasket on 4.6 and for some reason I have no spark on any cylenders changed crankshaft position sensor and camshaft position sensor and coilpacks and wires ....5 yrs ago I had a pats problem and I ran a wire from fuel pump to front seat and wire from positive side of battery to front seat and I twist them together to start and drive my car been doing it for over 5 yrs now (toggleswitch) so I'm not sure if it's a pats system or not this time and is there a way to run a wire from ccrm to something to get fire like hotwire it to get fire I been brokedown for over a month and I can't figure this out
 
1 - 1 of 1 Posts
Top