Mustang and Ford Performance Forums banner

1 - 5 of 5 Posts

·
Registered
Joined
·
37 Posts
Discussion Starter · #1 ·
Mods are in my sig. The first dyno was done with no cool down and with 1,326 miles on the car. My two best runs were:

424.0rwhp/407.3rwtq SAE
420.3rwhp/410.9rwtq SAE (10 min cool down after 2nd run)

The dyno sheets can be seen here:

http://www.msnusers.com/MustangMembers/shoebox.msnw?action=ShowPhoto&PhotoID=44

Looks like some tuning should gain me some extra power. Either a chip or the mafterburner will be in my future.
 

·
Registered
Joined
·
37 Posts
Discussion Starter · #3 ·
The dyno was done with the 3.2" pulley and the mods in my sig. I just ordered an Afterburner to help clean up the air-fuel. I should hopefully gain some mid-range torque and some hp.
 

·
Registered
Joined
·
37 Posts
Discussion Starter · #5 ·
Not quite sure what it added. I could definitely feel a difference, more torque in the lower to midrange. There are so many dyno's out there with cai and exhaust that I was just going to wait until I put the pulley on. I haven't seen too many 3.2" dyno's so I thought I would post mine. Once I get the Afterburner installed, I will post the before and after of the gains.
 
1 - 5 of 5 Posts
Top