Mustang and Ford Performance Forums banner
1 - 4 of 4 Posts

· Registered
Joined
·
683 Posts
Discussion Starter · #1 ·
For you drag race guys, who is using an engine diaper? What brand? Specifically, where are some good points to attach it. Planning to have a belly pan made but can't get it done in time for SCSN. I was given an RCI diaper to borrow, just needed a little advice on how to attach it.
 

· Administrator
Joined
·
9,832 Posts
For you drag race guys, who is using an engine diaper? What brand? Specifically, where are some good points to attach it. Planning to have a belly pan made but can't get it done in time for SCSN. I was given an RCI diaper to borrow, just needed a little advice on how to attach it.
Alex,

On a Hemi we attach to the exhaust header flange bolts. One on each side front and back and then just cinch it up to the pan.

Ed
 

· Registered
Joined
·
683 Posts
Discussion Starter · #3 ·
Ed

Thanks for the reply. I figured the flange studs were probably the best option as I've read a lot of other racers do it this way. Was just looking for a "modular" specific location that people have tried..
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top