Mustang and Ford Performance Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
637 Posts
Discussion Starter · #1 ·
Lets say I got a 5.4L expedition block with non PI heads. so I rebuild it with a better rotating assembly and want to install a 4v heads on it.. is that possible ? would I come across any wiring problems or so ? I will be using a 2003-2004 PCM from a mustang.

would there be any milling or drilling ?

another question is Do they sell rotating assemblies for the 6.8L excursion engines ? any shops you know of ?


Thanks.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top