Mustang and Ford Performance Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
10 Posts
Discussion Starter · #1 ·
Was doing 5.4 swap before I got the bug to just buy a terminator. Located north of Baltimore MD. Engine ran and I drove it from the lot to the garage where we pulled it out. All harnasses in tact (they were cut from the car side of the harnass) complete engine from accessories to flexplate and oil pan to intake. All spark plug holes looked good, compression was strong, oil and coolant looked good. There was one exhaust manifold stud that was broken (typical) but it is flush with exhaust manifold so once the manifold is pulled it is an easy removel. It's sitting on an engine stand in my garage. PM or email for more PICS. Will deliver or meet w/i 100 miles of 21152 for $.30 per mile. Looking for $500, this is a great motor to just drop in and go.
 

Attachments

1 - 2 of 2 Posts
Top