Mustang and Ford Performance Forums banner
1 - 5 of 5 Posts

·
Registered
Joined
·
520 Posts
Discussion Starter · #1 · (Edited)
I still have the following for sale:

-3 bolt tensioner (painted black) - $20 shipped
-MAC X-Pipe (For longtubes) - $120 shipped
-Romeo PI Cams w/ Bolts and Sprockets - $75 shipped
-(2) 2v Oil Pumps w/ pickup tubes - $25 shipped each
-Complete 2003 PI Engine Wire Harness - $55 shipped
-Set of 19lb Fuel Injectors (4-pintle tips) - Ebay/Offer
-96-98 Guage Cluster Bezel (Black) - Ebay/Offer
-Radio/HVAC Trim Bezel w/ AC Vents (Black) - Ebay/Offer
-(16) Set of PI Valve Springs in good shape - $18 shipped
-SCT 4-Bank Programmable Chip - $125 shipped
-96-98 Authentic Ford Saleen Racecraft Spark Plug Wires (Red) - $100 shipped
-4.6L 2v Stock Bore JE -17cc Dish Forged Pistons w/ approx 5k miles $290 shipped OBO
-4.6L 2v Manley .20 Forged -17 or -18cc Pistons (used, great condition, missing one piston pin lock.Can easily order from manley) $270 shipped OBO
-Bunch of stock 2003 and 1997 GT piston/rod combos in good condition - Offer

Parts for sale on ebay <---LINK
 

·
Registered
Joined
·
520 Posts
Discussion Starter · #3 ·
What kind of compression would these be good for ? I am running 01 heads in an 01 block
Same as stock, the stock pistions are -17cc or -18cc dish as well, so you are looking at right around the same as stock, give or take a fraction. So pretty much 9.6/9.7:1 compression ratio. Good for a boosted/power adder application.
 
1 - 5 of 5 Posts
Top