Mustang and Ford Performance Forums banner
1 - 3 of 3 Posts

· Registered
Joined
·
5 Posts
Discussion Starter · #1 ·
First off just want to say Hi to everyone, this is my first true post. Been mostly on the for sale section buying parts.

I purchased a '93 Mark8 engine from the junk yard that I'm in the process of rebuilding to put in my '98 stang. The car curently has a S/C v6 in it making 300hp, but the V8 will make much more when I'm done. Since the engine is not in the car and will not be for awhile I was wondering if someone could get me some dimensions of the stock cobra intake. I plan on making a sheet metal one to fit the B heads. I need the height from the bottom flange to the top and the length and width of the top part.


Thanks,
Corey.
 

· Registered
Joined
·
989 Posts
just cut the runner plate from the mark's intake get 6in runner and weld a box on top ot it then place youre tb where ever you want it...seems to be easy as it, or buy a mmr sheet metal intake ;) there not cheap but they are really sharp
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top