Mustang and Ford Performance Forums banner

1 - 5 of 5 Posts

·
Yes...it can be done
Joined
·
3,140 Posts
Discussion Starter · #1 ·
Hey guys, I happened to notice something about the Denscharger CAI setup today. The lower right bolt on the MAF rubs against the valve cover. Over time, it has taken a pretty good chunk out.

I have some pictures of the problem, and the remedy that I did to prevent future rubbing. Can someone host some pics for me?
 

·
Registered
Joined
·
36 Posts
Don't get me wrong. I've been very critical of DC's in the past. But this is the first time I've heard of this happening. I am fully aware of the bolt your talking about. The only time I scratched my valve cover was caused by me being bull-headed, and trying to install it without removing the entire intake assembly :p

Sounds to me like something isn't right with the way you installed it, or your MAF tube isn't straight.

Make sure and get those pics up here so we can take a look at them.
 

·
Registered
Joined
·
50 Posts
Mine scratched the valve cover on install, but is not touching now...
 
1 - 5 of 5 Posts
Top