Mustang and Ford Performance Forums banner
1 - 6 of 6 Posts

·
Registered
Joined
·
104 Posts
Discussion Starter · #1 ·
Help I can't figure out what the deal is I don't know if it is my shift points or what. But I am getting really frustrated with people talking about 12's while making less power than me. I am open to any suggestions on improvement. My best time on slicks goes like this. 60' = 1.745 330' = 5.386 1/8 = 8.458 @ 80.22 1000' = 11.117 1/4 = 13.344 @ 101.05 This run was made at around 3000' DA and weighing between 3450-3500 pounds. Run was also made with 28" X 9" M/T ET Drags. Launching at 5000 rpm and Shifting at 5500 rpms in every gear. So wtf is wrong here at this power level Shouldn't I easily be in the 12's any help greatly appreciated. Here is a dyno graph.
 

Attachments

·
Registered
Joined
·
12 Posts
I would have gotten 26" slicks and also make sure your powershifting...
 

·
Registered
Joined
·
492 Posts
My previous dyno sheet looks very similar to yours, minus a few RWHP. I was told to shift at 5200 rpms for my shift point. Last fall it ran 13.2 on radials with me shifting there. Something to try since it seems like your 60' is decent on slicks.
 

·
Registered
Joined
·
810 Posts
Too much tire for hp and gear, go to a 26 x 10 slick you should pick up 2 tenths. When you get into 3rd, I bet you can really notice the rpms drop way low and you wasting time building up rpms again. Your 28s are killing you. Just my opinion.
 
1 - 6 of 6 Posts
Top