Mustang and Ford Performance Forums banner
1 - 7 of 7 Posts

· Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
Hi, Does anyone know the T56 shifter bolt measurements. I have a guy selling a brand new B&M ripper shifter he says is for the T56. I don't have access to my car at the moment tp measure. Pictures on the net look the same but could just as easily be for a jeep or corvette. Thanks for any help.
 

· Administrator
Joined
·
9,833 Posts
Try calling them during normal business hours and asking them about their T56 shifter bolt measurement. There will not be a better authority than the manufacturer.
 

· Registered
Joined
·
1,758 Posts
Are you asking for the measurements between the four base plate holes? It sounds so. If so, I will check the measurements quickly from my T-56 shifter gasket. Be right back.
Bob Arthure
Stang Shifter Gaskets
 
1 - 7 of 7 Posts
Top