Mustang and Ford Performance Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
33 Posts
Discussion Starter · #1 ·
Finally got things lined up to get the 03 on the dyno for a baseline pull. Just about where I expected for a second run car, 358 Hp and 358 Tq. A/F looked pretty typical for a stock tune, dropped below 10:1 at 5500 rpms. The car is at the dealer having a complete IRS installed, gear whine kept getting worse and the dealer went ahead and decided to replace the entire unit. As soon as I get it back it will be time to install the goodies from Rick (CAI, 310 pulley, and chip). Hopefully with these mods and a Bassani xpipe and cat back we will see 450 but will not be disappointed with 440.
 

·
The Ubiquitous Jimmy V.
Joined
·
3,323 Posts
You will not be disapointed with the setup you chose.It has been good for 440 to 450 on all the cars i know of that used it.

358 if SAE is right on.


Jim V.
 
1 - 2 of 2 Posts
Top