Mustang and Ford Performance Forums banner

1 - 1 of 1 Posts

·
Registered
Joined
·
176 Posts
Discussion Starter · #1 ·
Good evening everyone,
I haven’t been on this forum for quite some time but remember it being a wealth of knowledge in the early 2000s. My car has remained pretty much untouched since about 2012, and I’m looking to get a little more serious and finally ditch the manual and go with a T400 for better ETs as well as increased power capacity.
My question is does anyone know off hand what the proper driveshaft length is for a T400 in a SN95 with a 8.8 rear? Also anyone out there know if any off the shelf headers fit around that trans?
Thanks in advance for your help!
 
1 - 1 of 1 Posts
Top